Application Connector Table

connector is the pin location on the headers in the middle of the Application Board.
app board shows how the signal at that location has been used on the Application Board.

Connector	app board	Connector	app board
J1.01	Analog In 4	J3.01	CANL
J1.02	+3.3V	J3.02	CANH
J1.03	Analog In 6	J3.03	Pad CANRX
J1.04	Analog In 5	J3.04	Pad CANTX
J1.05	Analog In 0	J3.05	Servo 3
J1.06	Analog In 7	J3.06	Servo 2
J1.07	Analog In 2	J3.07	GND
J1.08	Analog In 1	J3.08	Servo 1
J1.09	ShiftReg.OE	J3.09	Digital Out 0
J1.10	Analog In 3	J3.10	GND
J1.11	GND	J3.11
J1.12	GND	J3.12	Digital Out 5
J1.13	GND	J3.13	Digital Out 6
J1.14	GND	J3.14	GND
J1.15	Pad PA14	J3.15	Pwm 0
J1.16	App LED 1	J3.16	Pwm 1
J1.17	ShiftReg.DO	J3.17	Pwm 2
J1.18	App LED 0	J3.18	Pwm 3
J1.19	ShiftReg.CLK	J3.19	Digital Out 7
J1.20	ShiftReg.LATCH	J3.20	Servo 0
		J3.21	Digital Out 4
J2.01	GND	J3.22	GND
J2.02		J3.23	App LED 3
J2.03	GND	J3.24	App LED 2
J2.04	+3.3V
J2.05	JTAG	J4.01
J2.06	JTAG	J4.02	+3.3V
J2.07	Pad PA29	J4.03	GND
J2.08	JTAG	J4.04	GND
J2.09	Pad – JTAGSEL	J4.05	EthernetJack.RX+
J2.10	JTAG	J4.06	EthernetJack.RX-
J2.11	JTAG	J4.07	EthernetJack.A3.3V
J2.12	Pad PA30	J4.08	EthernetJack.TX+
J2.13	Pad RX / GPIO1	J4.09	EthernetJack.TX-
J2.14	Pad TX / GPIO0	J4.10	GND
J2.15	Pad RTS / GPIO2	J4.11	EthernetJack.Led
J2.16	Digital Out 3	J4.12	EthernetJack.Led
J2.17	Pad CTS / GPIO3	J4.13
J2.18	Digital Out 1
J2.19	Digital Out 2
J2.20	GND
J2.21	Erase Jumper
J2.22	USB +
J2.23	GND
J2.24	USB -
J2.25	GND
J2.26	USB+5V

MakingThings