how to add zigbee in this circuit?

Posted by saurabh at July 09. 2008

Hi,

I came across a supposedly simple circuit which I was looking for as a starting point at http://www.glacialwanderer.com/_blog/blog2008/04_April/hb_relay5.jpg hosted at the excellent article at http://www.glacialwanderer.com/hobbyrobotics/?p=9.

I think migrating this to a MAKE controller kit should not be much difficult. My question is, how can I separate the bulb from the Make Controller baed on a xbee chip? I would like the bulb not directly connected to the MAKE board.

Re: how to add zigbee in this circuit?

Posted by Liam Staskawicz at July 11. 2008

Unless I've misunderstood, you can simply substitute the desired output from the XBee modeule for the "Arduino Pin 3" output in the schematic you linked.

Document Actions

Send this
Print this

Sections

how to add zigbee in this circuit?

how to add zigbee in this circuit?

Re: how to add zigbee in this circuit?

Document Actions