command to change the channel Xbeepro module in X-ctu

Posted by yousuf uddin at September 18. 2008

hi,

what is the command for to change the channel Xbeepro (V.1047) module in X-ctu .I tried with ATCHE,WR is not working I want to configure it channel no. 12.

Re: command to change the channel Xbeepro module in X-ctu

Posted by Liam Staskawicz at September 23. 2008

It sounds like you tried sending the command manually. Did you try setting it in the read/write screen where it basically gives you a dropdown list of the appropriate options? This might be more likely to work.

Re: command to change the channel Xbeepro module in X-ctu

Posted by yousuf uddin at October 06. 2008

Thankq........but I am using X-CTU version 5.1.4.1there I don't have the dropdown option thats why I am trying it manually

and one more thing is my coordinator will receive the data from endevice there if may any event happened but after some time going into sleep mode if there is no event change happening eventhough SM=0(no sleep) configured

Re: command to change the channel Xbeepro module in X-ctu

Posted by yousuf uddin at November 04. 2008

hi plz respond as early ,

(last) low power module send the data when any event changed(configured as enddevice/router) is not able to communicate with my coordinator which is connected to PC through COM port when I switch off power for the low power module which is in b/w the last module and my coordinator

Sections

command to change the channel Xbeepro module in X-ctu