Sections
You are here: Home → Documentation → Tutorials → Using I2C on the Make Contoller Board → Where to cut the traces on the back of the controller

Where to cut the traces on the back of the controller

Cut the traces on the back of the Make Controller Board, so the vias can be used as soldering pads. If you cut the trace between Q1 and R20, you'll need to re-connect it with a wire as shown. Note the small bits of solder that still need to be cleaned up.

Where to cut the traces on the back of the controller
Click to view full-size image… — Size: 1.5 MB
Document Actions
Log in


Forgot your password?
New user?